This forum is dedicated to those hobbyists with the 3-in-1 metalworking machines. Mill-Drill-Lathes. Tips, techniques, modification and use of these machines is topical.
Moderator: Harold_V
-
SteveM
- Posts: 7423
- Joined: Mon Jun 27, 2005 6:18 pm
- Location: Connecticut
Post
by SteveM » Mon Jan 04, 2021 2:33 pm
If the original poster isn't interested in the VFD, I would be.
Steve
toddalin wrote: ↑Mon Jan 04, 2021 2:11 pm
I got a TECO JNEV-101-H1 brand new when I got my machine. But it doesn't have the capacity for my machine and has been on the shelf ever since. Is this something you could use? (1HP/750 Watt)
Just like this one:
https://dealerselectric.com/JNEV-101-H1.asp
-
VelocityDuck
- Posts: 23
- Joined: Mon Dec 07, 2020 6:14 am
Post
by VelocityDuck » Mon Jan 04, 2021 6:25 pm
Thanks Steve. I appreciate the offer. But I have no idea if it will work. The spec sheet shows some differences. They may be relevant, they may not. I just don't know.
-
toddalin
- Posts: 269
- Joined: Tue Nov 13, 2012 1:10 pm
- Location: Orange County, CA
-
Contact:
Post
by toddalin » Wed Jan 06, 2021 3:27 pm
SteveM wrote: ↑Mon Jan 04, 2021 2:33 pm
If the original poster isn't interested in the VFD, I would be.
Steve
toddalin wrote: ↑Mon Jan 04, 2021 2:11 pm
I got a TECO JNEV-101-H1 brand new when I got my machine. But it doesn't have the capacity for my machine and has been on the shelf ever since. Is this something you could use? (1HP/750 Watt)
Just like this one:
https://dealerselectric.com/JNEV-101-H1.asp
Will keep you in mind.
-
toddalin
- Posts: 269
- Joined: Tue Nov 13, 2012 1:10 pm
- Location: Orange County, CA
-
Contact:
Post
by toddalin » Fri Jan 08, 2021 2:37 pm
SteveM wrote: ↑Mon Jan 04, 2021 2:33 pm
If the original poster isn't interested in the VFD, I would be.
Steve
Piece was spoken for and shipped.