Page 3 of 3
Re: Toolpost sizing
Posted: Sat Oct 01, 2016 5:20 pm
by BadDog
Just for reference, AXA goes up to 1/2" tooling, BXA only gets you to 5/8", so not a big difference there.
Re: Toolpost sizing
Posted: Mon Oct 17, 2016 1:31 pm
by serval59
Re: Toolpost sizing
Posted: Mon Oct 17, 2016 3:59 pm
by BadDog
The bolt used in the t-slot shown in the first pic had me a bit concerned, but it looks like you replaced it as shown further down in the pics. It might be fine on a 3-n-1, but I've seen too many broken t-slots to be comfortable using something with that little surface contact.
In any case, congrats on getting it set up, I hope it serves you well!