Hi all,
There was a Clausing turret attachment that fits a model 4900 lathe at Cabin Fever over the weekend. It was sitting on the floor in the consignment area....I went to buy it as I was getting ready to leave and either it had been purchased or picked up by the seller. If the seller picked it up and would still like to sell it; I'll give it a good home.
Thanks,
Andy Pullen
Clausing lathe turret attachment
Moderators: gwrdriver, Harold_V
-
- Posts: 2166
- Joined: Thu May 22, 2003 8:17 am
- Location: Bel Air, MD
Clausing lathe turret attachment
Clausing 10x24, Sheldon 12" shaper, ProtoTrak AGE-2 control cnc on a BP clone, Reed Prentice 14" x 30", Sanford MG 610 surface grinder, Kalamazoo 610 bandsaw, Hardinge HSL speed lathe, Hardinge HC chucker, Kearney and Trecker #2K plain horizontal mill, Haas TL-1 lathe.