SD-45-T2 drawings

This forum is dedicated to Riding Scale Railroading with propulsion using other than steam (Hydraulics, diesel engines, gas engines, electric motors, hybrid etc.)

Moderators: Harold_V, WJH

Post Reply
Posts: 2
Joined: Sat Jul 28, 2018 6:01 pm

SD-45-T2 drawings

Post by Railroaddaddy » Mon Dec 31, 2018 3:24 pm

I want to build a 1.6 scale SD-45-T2 locomotive.I am searching for any blueprints that are available.
Thanks Bob

Posts: 69
Joined: Sun Jan 25, 2009 12:43 pm
Location: Barberton Ohio

Re: SD-45-T2 drawings

Post by ERIE S-1 BERKSHIRES » Wed Jan 02, 2019 6:54 pm

On page 149 of Model Railroader cyclopedia volume 2 diesel locomotives, is a good side view front and rear line drawings, I hope this will help you

Posts: 1469
Joined: Tue Aug 22, 2017 10:33 am
Location: Wa State

Re: SD-45-T2 drawings

Post by rkcarguy » Thu Jan 03, 2019 12:40 am

If you can't find anything with dimensions, I don't think it would hurt to buy a quality HO scale model and a set of cheap machinist calipers, and start scaling it up. That's what I did for my Baldwin S-12 I'm working on, plus I used what few dimensions/drawings I could find online as "check" dimensions.
In my case our local train show provided a $10.00 Athearn Blue Box S-12, it was right on except the hood width was wider to fit the electric motor, and it turned out to be a blessing because my Honda GX390 and hydraulic drive setup will just barely fit.

User avatar
Posts: 52
Joined: Sun Oct 05, 2003 7:02 pm
Location: Knoxville, Tennessee

Re: SD-45-T2 drawings

Post by davidqueener » Sat Feb 09, 2019 1:53 pm

Please contact me offline, and I think I can help you with some prototype drawings.

Dave Queener
Pastor, St. Paul Presbyterian Church (865) 209-5654

Owner, Cumberland Model Engineering (865) 333-5712

Post Reply