UK request for parts to be made - Max 46.5mm Dia Stainless
Posted: Sun Nov 01, 2015 7:05 pm
Greetings all!
As per the title I am after a few bespoke pieces made from stainless steel (polished of course) for my new show bike - a 1995 Suzuki RF900
Part numbers obtained from http://www.robinsonsfoundry.co.uk/conte ... rframe.htm
The largest diameter piece is:
- spacer for the front wheel at 46.5mm part number 54740-17C00
- spacer for the rear wheel is about 40mm part number 64741-17E00
then there is a the really bespoke bit that would look the nuts - the covers that are plastic, but to be made from stainless, I have seen some done. Larger one is 46mm max diameter:
- 43585-47D01
- 43585-21E00
The couple of bits I need for the front brake lever are
- 57437-32C01 (but with a head like 57431-05A00)
- 57431-17C00 (but with a head like 57431-05A00)
If this is within your skill set and lathe capability then please pm me with an indication of cost. If accepted I can then post you spares of all of the above parts for you to measure and copy.
Thank you for taking the time to look at this for me.
I look forward to hearing from you.
As per the title I am after a few bespoke pieces made from stainless steel (polished of course) for my new show bike - a 1995 Suzuki RF900
Part numbers obtained from http://www.robinsonsfoundry.co.uk/conte ... rframe.htm
The largest diameter piece is:
- spacer for the front wheel at 46.5mm part number 54740-17C00
- spacer for the rear wheel is about 40mm part number 64741-17E00
then there is a the really bespoke bit that would look the nuts - the covers that are plastic, but to be made from stainless, I have seen some done. Larger one is 46mm max diameter:
- 43585-47D01
- 43585-21E00
The couple of bits I need for the front brake lever are
- 57437-32C01 (but with a head like 57431-05A00)
- 57431-17C00 (but with a head like 57431-05A00)
If this is within your skill set and lathe capability then please pm me with an indication of cost. If accepted I can then post you spares of all of the above parts for you to measure and copy.
Thank you for taking the time to look at this for me.
I look forward to hearing from you.