Page 1 of 1

Wanted - Wire EDM work

Posted: Thu Mar 22, 2012 4:17 pm
by Steelart99
I have a couple of titanium knife components that I'd like to have cut with a wire EDM. I can cut and stack my .045 titanium plate to yield a thickness of about 0.72" to make it easier to cut. Total number of pieces will be 80-100 (depending on nesting, clamping requirements, etc.). The total area to be cut is about 45 sq. in.

If there is anyone who is willing to quote this small job, let me know and I can provide AutoCad drawings.