I can't delete posts in this forum, so that must be a knob for fools to turn. I figured out it is a 5/16.
.
I see Lyndex NMTB fixed 0.3" endmill holder. Is this likely to be 0.300" or just a loose guess at 1/4"? Is 0.3" a thing, what are you holding in that?
I need a 1/4" holder for my mill, actually Erickson QC30, but I did try a Lyndex and they fit.
Never Mind (0.3" Endmill Holder)
Never Mind (0.3" Endmill Holder)
Standards are so important that everyone must have their own...
To measure is to know - Lord Kelvin
Disclaimer: I'm just a guy with a few machines...
To measure is to know - Lord Kelvin
Disclaimer: I'm just a guy with a few machines...