I am fabricating a couple of castellated nuts that have a 7/16" hex and a 5/16-24 thread. They are going to be retained by a 1/16" cotter pin. So far I have cut the slot depths at .0625" and the widths at .0625". What is the accepted standard for slot depths and widths?
Thank you,
Harper
Castellated nut slot depths
Re: Castellated nut slot depths
Standards for a 5/16" nut are .093" depth and width of the slot.
This information is readily available in Machinery's Handbook.
H
This information is readily available in Machinery's Handbook.
H
Wise people talk because they have something to say. Fools talk because they have to say something.
Re: Castellated nut slot depths
.078" slot width for a 1/16" cotter pin.
Usually, a 5/16" fastener 1/2" hex, would use a 3/32" cotter pin, and a 1/4" fastener 7/16 hex, would use a 1/16" cotter pin.
You have a combination.
Usually, a 5/16" fastener 1/2" hex, would use a 3/32" cotter pin, and a 1/4" fastener 7/16 hex, would use a 1/16" cotter pin.
You have a combination.
Glenn
Operating machines is perfectly safe......until you forget how dangerous it really is!
Operating machines is perfectly safe......until you forget how dangerous it really is!
Re: Castellated nut slot depths
Thank you Glenn and Harold! Your help is much appreciated.
Harper
Harper