Page 3 of 3

Re: What Size Quick Change for Enco 13 x 40?

Posted: Tue Jan 15, 2019 1:45 pm
by johnfreese
As WLW posted, he had to put a riser under the toolpost to get the right center height. The toolpost was too small for the lathe. Conversely if you buy a toolpost too large for the lathe the it may not be possible get the toolholder low enough to put the tool at the right center height.

Re: What Size Quick Change for Enco 13 x 40?

Posted: Tue Jan 15, 2019 7:25 pm
by Mr Ron
An AXA tool holder works well on my 11" Sheldon. A BXA would be too large.