All discussion about lathes including but not limited to: South Bend, Hardinge, Logan, Monarch, Clausing and other HSM lathes, including imports
2 posts • Page 1 of 1
I am on the search for the M6-810 mounting plate attachment for the Atlas 618 to be used on its bench. From research I do understand that this is an older part and very sparse. Would anyone happen to know the whereabouts of one I can purchase? Any help would be greatly appreciated I have been searching for quite some time!
Good luck in your search! If you are doing a restoration, then of course, you'll just have to be patient and hope one turns up. If you are looking to get the machine up and running, you may have to get creative and just fab something up.