Lead screw bearing stack on mini lathe

All discussion about lathes including but not limited to: South Bend, Hardinge, Logan, Monarch, Clausing and other HSM lathes, including imports

Moderators: Harold_V, GlennW

kjkrum
Posts: 4
Joined: Sun Apr 04, 2021 4:35 pm

Re: Lead screw bearing stack on mini lathe

Post by kjkrum » Sat Apr 10, 2021 9:08 pm

Bill Shields wrote:
Thu Apr 08, 2021 3:48 pm
is there a thrust bearing at the OTHER END of the lead screw? => gear end?
No, the headstock end of the lead screw just passes through a bushing. Its position seems to be entirely determined by the two thrust bearings on opposite sides of the block on the tailstock end.

Post Reply