Easy Power Tailstock Feed

All discussion about lathes including but not limited to: South Bend, Hardinge, Logan, Monarch, Clausing and other HSM lathes, including imports

Moderators: Harold_V, GlennW

Post Reply
c7z06
Posts: 6
Joined: Tue Dec 08, 2020 1:16 pm

Easy Power Tailstock Feed

Post by c7z06 » Fri May 07, 2021 2:38 pm

Many years ago I came up with a simple power feed arrangement for the tailstock on my 9" South Bend when drilling, tapping, etc.

I got a two piece clamping shaft collar with an ID the same size as my tailstock spindle. Then I made a forked bracket that engaged the shaft collar as shown in the photo. Bingo, I had a power tailstock feed. Just slightly loosen the tailstock clamp and let the carriage pull it along at the desired feed rate.
power tailstock 308102020_00001.jpg
power tailstock 308102020_00000.jpg

Russ Hanscom
Posts: 1836
Joined: Wed Mar 15, 2006 11:10 pm
Location: Farmington, NM

Re: Easy Power Tailstock Feed

Post by Russ Hanscom » Fri May 07, 2021 4:31 pm

Very good.

Post Reply