One Stop Referance

This is where bits of wisdom will be stored, a frequently asked question section with answers.

Moderators: Harold_V, WJH

Post Reply
User avatar
Dave_C
Posts: 960
Joined: Mon Apr 21, 2008 10:34 am
Location: Springfield. MO.

One Stop Referance

Post by Dave_C » Mon Aug 29, 2016 10:07 am

This link may have been posted in the past but I found it to be of good use as it has pipe thread charts, feeds and speeds calculator, insert and chip breaker descriptions, end mill stuff, even wood working stuff!

http://www.carbidedepot.com/resources.htm

Dave C.
I learn something new every day! Problem is I forget two.

User avatar
SteveM
Posts: 6853
Joined: Mon Jun 27, 2005 6:18 pm
Location: Connecticut

Re: One Stop Referance

Post by SteveM » Mon Aug 29, 2016 1:14 pm

That is my go-to reference for inserts and toolholders. Used it just last night.

A lot of other good stuff there. Never scrolled down far enough to see.

Steve

Post Reply