Page 1 of 1

One Stop Referance

Posted: Mon Aug 29, 2016 10:07 am
by Dave_C
This link may have been posted in the past but I found it to be of good use as it has pipe thread charts, feeds and speeds calculator, insert and chip breaker descriptions, end mill stuff, even wood working stuff!

http://www.carbidedepot.com/resources.htm

Dave C.

Re: One Stop Referance

Posted: Mon Aug 29, 2016 1:14 pm
by SteveM
That is my go-to reference for inserts and toolholders. Used it just last night.

A lot of other good stuff there. Never scrolled down far enough to see.

Steve