Feedback requested, PRR junction box

This forum is dedicated to the Live Steam Hobbyist Community.

Moderators: Harold_V, WJH, cbrew

ebtfan
Posts: 93
Joined: Mon Jul 02, 2007 12:10 am
Location: Lancaster, PA

Re: Feedback requested, PRR junction box

Post by ebtfan » Sun Oct 06, 2019 8:09 pm

Thanks for making these junction boxes available. I am planning to use 5/32 tubing and will need four of the boxes.
Dan

Steambldr1
Posts: 3
Joined: Tue Jun 04, 2019 8:30 am

Re: Feedback requested, PRR junction box

Post by Steambldr1 » Tue Oct 08, 2019 9:23 pm

It would be nice if you could size it down and offer it in 1" scale also.
Tim

User avatar
Sandiapaul
Posts: 399
Joined: Wed Jan 07, 2004 8:04 am
Location: Princeton, NJ

Re: Feedback requested, PRR junction box

Post by Sandiapaul » Wed Oct 09, 2019 6:45 pm

They can be scaled to any size, and I will do that!

Steambldr1
Posts: 3
Joined: Tue Jun 04, 2019 8:30 am

Re: Feedback requested, PRR junction box

Post by Steambldr1 » Wed Oct 09, 2019 7:40 pm

Thank you Paul! I will be getting a few for a upcoming Pennsy project. The nice thing about Pennsylvania design locomotives is a lot of parts were interchangeable across many classes of locomotives.

User avatar
Sandiapaul
Posts: 399
Joined: Wed Jan 07, 2004 8:04 am
Location: Princeton, NJ

Re: Feedback requested, PRR junction box

Post by Sandiapaul » Thu Oct 10, 2019 5:23 am

One thing...in smaller sizes there might be trouble with the lettering. I can check and make sure. Yeah if you start looking at Pennsy photos those boxes are on nearly all locos!

User avatar
Andypullen
Posts: 2008
Joined: Thu May 22, 2003 8:17 am
Location: Bel Air, MD

Re: Feedback requested, PRR junction box

Post by Andypullen » Sat Oct 19, 2019 9:35 am

Hey Paul,

I'll look at my E6 prints and get back to you.

Andy
Clausing 10x24, Sheldon 12" shaper, ProtoTrak AGE-2 control cnc on a BP clone, Reed Prentice 14" x 30", Sanford MG 610 surface grinder, Kalamazoo 610 bandsaw.

User avatar
Andypullen
Posts: 2008
Joined: Thu May 22, 2003 8:17 am
Location: Bel Air, MD

Re: Feedback requested, PRR junction box

Post by Andypullen » Mon Oct 21, 2019 12:06 pm

3/16"
Clausing 10x24, Sheldon 12" shaper, ProtoTrak AGE-2 control cnc on a BP clone, Reed Prentice 14" x 30", Sanford MG 610 surface grinder, Kalamazoo 610 bandsaw.

Post Reply