Two cylinder beam engine drawings

This forum is dedicated to the Live Steam Hobbyist Community.

Moderators: Harold_V, WJH, cbrew

Post Reply
User avatar
FLtenwheeler
Posts: 1401
Joined: Sun Jan 05, 2003 8:47 am
Location: Florida, on the Lake Wales Ridge

Two cylinder beam engine drawings

Post by FLtenwheeler » Mon May 10, 2021 1:29 pm

I am looking for a set of drawings for the 2 cylinder beam engine. It is large with a 16” flywheel.
Attachments
A1F7CC32-D000-4034-92B2-8A353AFF96AA.jpeg
F271CC98-BBA2-4942-A932-B8FF46C8628D.jpeg
He who dies with the most unfinished projects: Should of put more time into their hobby.

User avatar
gwrdriver
Posts: 3235
Joined: Mon Jan 06, 2003 10:31 am
Location: Nashville Tennessee

Re: Two cylinder beam engine drawings

Post by gwrdriver » Mon May 17, 2021 7:35 am

I was waiting to see if you had any response, and I hoped you would. In the meantime (as no responses poured in), I was thinking one alternative would be to reverse-engineer the castings and develop a set of new drawings. That would take some time, and the usual knowledge to do it, but it could certainly be done. The other of course would be to locate an existing model and measure it up.
GWRdriver
Nashville TN

steamingon
Posts: 54
Joined: Sun May 08, 2005 8:02 pm

Re: Two cylinder beam engine drawings

Post by steamingon » Mon May 17, 2021 12:05 pm

Hello, your request for drawings would be more appropriate at these forums.

www.homemodelenginemachinist.com
www.officeofsteamforum.com
www.modelenginemaker.com

I believe those castings were sold in the 80's and may have advertised in LS

Post Reply