Here is a pic of the spare 3 jaw Southbend chuck I bolted onto a flatplate and had the welder make two slots on an arc. Much more stable than a vice, I used it at work before retiring.
lathe chuck on mill table
Moderator: Harold_V
-
- Posts: 6
- Joined: Tue Dec 14, 2010 9:51 pm
- Location: Woodlawn, On ( Ottawa)
lathe chuck on mill table
57 wagon 408"BB with 14' Bonair travel trailer,71 Nova 355"SB, 07 2500HD with 26.5 Prowler 5th wheel travel trailer, 09 Impala LT, John Deere lawn tractor, CDN coordinator for ChevyTalk.org,
http://www.picturetrail.com/sfx/album/l ... rys57wagon
http://www.picturetrail.com/sfx/album/l ... rys57wagon
Re: lathe chuck on mill table
what sort of work was it suited for?
-
- Posts: 6
- Joined: Tue Dec 14, 2010 9:51 pm
- Location: Woodlawn, On ( Ottawa)
Re: lathe chuck on mill table
We had to cut slots across shafts and our mill vice did not have V's in the jaw to keep the shaft square. This way you were always on center. I haven't used it for anything else as yet.
57 wagon 408"BB with 14' Bonair travel trailer,71 Nova 355"SB, 07 2500HD with 26.5 Prowler 5th wheel travel trailer, 09 Impala LT, John Deere lawn tractor, CDN coordinator for ChevyTalk.org,
http://www.picturetrail.com/sfx/album/l ... rys57wagon
http://www.picturetrail.com/sfx/album/l ... rys57wagon
Re: lathe chuck on mill table
retiredmachinist,
Picture link is bad..
Ken.
Picture link is bad..
Ken.
One must remember.
The best learning experiences come
from working with the older Masters.
Ken.
The best learning experiences come
from working with the older Masters.
Ken.
-
- Posts: 6
- Joined: Tue Dec 14, 2010 9:51 pm
- Location: Woodlawn, On ( Ottawa)
Re: lathe chuck on mill table
Thanks Ken for the heads up, I re- pasted the link to my PictureTrail site onto my signature, I hope it works for you, Henry.
57 wagon 408"BB with 14' Bonair travel trailer,71 Nova 355"SB, 07 2500HD with 26.5 Prowler 5th wheel travel trailer, 09 Impala LT, John Deere lawn tractor, CDN coordinator for ChevyTalk.org,
http://www.picturetrail.com/sfx/album/l ... rys57wagon
http://www.picturetrail.com/sfx/album/l ... rys57wagon
Re: lathe chuck on mill table
Henry,
You are very welcome.
You and little Henry have some very cool toy's
Ken.
You are very welcome.
You and little Henry have some very cool toy's
Ken.
One must remember.
The best learning experiences come
from working with the older Masters.
Ken.
The best learning experiences come
from working with the older Masters.
Ken.