A quick riding car
Moderator: Harold_V
-
- Posts: 434
- Joined: Fri Dec 16, 2011 1:00 am
- Location: Somewhere south of Mt. Katahdin
- Contact:
A quick riding car
Did a little casting for myself for a change, my birthday party is this weekend and I need a riding car for passenger service. I'm laying down a temporary track to run my switcher on. So, I got into my pattern stash and pulled out my Bettendorf truck set. I've made these for other people, but haven't had a chance to make a set for myself. I'll be machining them over the next few days, and putting them under a simple flat car that I also need to make.
"If you took the bones out they wouldn't be crunchy!" -Monty Python's Flying Circus
- Erskine Tramway
- Posts: 390
- Joined: Wed Sep 10, 2014 4:13 pm
- Location: South Dakota
- Contact:
Re: A quick riding car
Good looking castings.
Mike
Mike
Former Locomotive Engineer and Designer, Sandley Light Railway Equipment Works, Inc. and Riverside & Great Northern Railway 1962-77
BN RR Locomotive Engineer 1977-2014, Retired
BN RR Locomotive Engineer 1977-2014, Retired
- steamin10
- Posts: 6712
- Joined: Sun Jun 08, 2003 11:52 pm
- Location: NW Indiana. Close to Lake Michigan S. tip
Re: A quick riding car
Are those wheels aluminum Cast by you?
Big Dave, former Millwright, Electrician, Environmental conditioning, and back yard Fixxit guy. Now retired, persuing boats, trains, and broken relics.
We have enough youth, how about a fountain of Smart. My computer beat me at chess, but not kickboxing
It is not getting caught in the rain, its learning to dance in it. People saying good morning, should have to prove it.
We have enough youth, how about a fountain of Smart. My computer beat me at chess, but not kickboxing
It is not getting caught in the rain, its learning to dance in it. People saying good morning, should have to prove it.
-
- Posts: 434
- Joined: Fri Dec 16, 2011 1:00 am
- Location: Somewhere south of Mt. Katahdin
- Contact:
Re: A quick riding car
Nope, bronze. Red brass, really, I think, I had someone give me a bucket of plumbing fittings a while back and I put them to use. Should hold up fairly well, I think, and I didn't feel up to doing cast iron that day. Should be a little easier to finish as well. My cast wheels tend to be on the hard side, still figuring out cast iron.
"If you took the bones out they wouldn't be crunchy!" -Monty Python's Flying Circus